Toyota RAV4
Cabin Air Filter Replacement Guide
How to clean or replace the HVAC cabin
air filter element in a third generation 2006 to 2012 Toyota RAV4 SUV.
 Upper & Lower Glove Boxes |
 Open Lower Glove Box |
 Damper Arm On Right |
||
|
||||
 Pop Off Damper Arm |
 Pull Sides Inward |
 Release Box Side Stops |
||
| The first two steps
are to sit in the front passenger seat of the vehicle and open the lower
glove box. Then the contents of the glove box. Next move to the right side of the lower glove box and locate the black plastic damper arm. Gently pull the damper arm off its plastic mounting peg. Firmly push the two side walls of the glove box towards each other to release the black plastic side stops. Lower the glove box down to the floor mat. |
||||
 Lower Glove Box |
 Filter Cover & Blower Motor |
 Press Release Tab On Right |
||
| Behind the glove
box, you'll see the black plastic blower motor housing and the rectangular
cabin air filter cover. Press the release tab on the right side of the filter cover, swing it open towards yourself, and pull the tab on the left side out of its slot. |
||||
|
|
||||
 Swing Filter Cover Open |
 Old White Cabin Filter |
 Slide Filter Straight Out |
||
| Slide the old white cabin air filter element straight out of its slot. If the old filter has an "Air Flow" indicator arrow, it should be pointing down. The OEM filter on this 2012 RAV4 had the word "UP" printed on it with an arrow pointing upwards. | ||||
 Vacuum Old Filter Clean |
 Filter Housing & A/C Blower |
 Air Flow Arrow Pointing Up |
||
| If your old filter
looks relatively white, tap out the large debris and clean it with a vacuum
before re-installing it. If your old filter is dark grey or black and clogged with dirt, dust, hair, insects, leaves and other debris, it should be replaced with a new element. Slide the cleaned or new cabin air filter straight in to the slot in the blower motor housing with the "UP" arrow pointing in the correct direction. If the new filter has an "Air Flow" indicator arrow, the arrow should be pointing down towards the floor mat. |
||||
 Filter Cover "Up" Arrow |
 Insert Tab In Slot On Left |
 Push Right Side Closed |
||
| Line up the
rectangular cover over the filter housing with the "UP" arrow pointing in
the correct direction.
First insert the tab on the left side of the filter cover in its slot. Then swing the cover closed and push on the right side until the fastener clip snaps in to place. Double check that the filter cover is secure. |
||||
 Re-Insert Left & Right Stops |
 Pop On Damper Arm |
 Close Lower Glove Box |
||
| Raise the glove box
and firmly push inwards on the side walls to re-insert the black plastic
side stopper pegs. Pop the damper arm on the outer right side wall of the glove box back on to its mounting peg. Close the lower glove box to complete the job. For more,
check out my other
Toyota RAV4 Repair & Maintenance Guides. |
||||
If you found this guide to be helpful,
please consider making a small donation by clicking on the PayPal.com
"Donate" button located to the right of this paragraph. Thank you!
 (Note: I am not a registered charity. Donations are not tax deductible.) |